Borivali has old low buildings in IC Colony and Shimpoli, and new towers that have replaced many of them. The old bathrooms often have a sunken floor. The new ones are often smaller than the flats they replaced. Both change how a shower enclosure is planned, and in Mumbai we see both on one street.
Glass on a sunken bathroom floor in IC Colony
Many old flats in IC Colony and Shimpoli have a bathroom floor set lower than the rest of the flat. There is a step down at the door. Inside, the shower corner is sometimes lower again.
That inner step is where the glass goes. We set the floor channel along the edge of the step. The glass sits on the higher floor and the water stays on the lower one.
The step edge is often chipped or rounded with age. We check it at the measuring visit. Where it is too worn to hold a channel, we fit the glass just inside the step on the lower floor instead.
A smaller bathroom in a redeveloped Borivali flat
When an old society is rebuilt, the new flats are often laid out differently. The bathroom is sometimes smaller than the one the family had before.
A small bathroom still takes a glass enclosure, but the shape changes. A corner cubicle with two fixed sides and a door on the diagonal uses the least floor. A sliding door uses none.
We measure the bathroom as it is, not as the brochure drew it. Finished tiles and plaster change the sizes. Then we show you two or three layouts and say which one leaves the most room to move.
A shower door for a bathroom everyone uses
In many Borivali homes one bathroom serves a large family. The shower door is opened and closed many times a day, and the hinges carry the load.
So for a busy family bathroom we fit heavier hinges than the panel strictly needs. We also fit a handle on both sides and a magnetic seal on the door edge. The door then closes without a push.
A sliding door is another good answer here. It has no hinges to wear and cannot be left open across the room. Which suits you depends on the space in front of the shower.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















