Sanpada mixes new towers near the station with the lower sector blocks of Juinagar. The two kinds of building ask different things of a shower enclosure. In a tower, the lift carries a full-height panel and the walls are usually straight. In a low block, the stairs set the panel size. We ask which you live in when you book, and we measure for it.
One panel by lift, or two panels by the stairs
In the Sanpada towers, a service lift usually takes a panel of full height. We can fit a single frameless panel and a door without a joint.
In the Juinagar blocks there is often no lift, or a small one. The staircase turns at each landing. A tall panel will not pass the turn.
So we make the enclosure as two panels with a slim joint. From a step away the joint is hard to see. We decide this at the measuring visit, because toughened glass cannot be trimmed afterwards.
Damp bathrooms in Sanpada and the glass that suits them
Bathrooms here stay damp for months. The monsoon lasts from June to September, and the air is humid for longer. A bathroom with a small window never fully dries.
Clear glass shows water marks and soap film quickly in that air. Frosted or lightly tinted glass hides both. It also gives privacy where the bathroom door opens onto a bedroom.
We also leave a wider gap at the bottom of a fixed panel in these bathrooms. Air moves under it and the floor dries faster.
Fittings that last in a sea-side sector
Sanpada's towers along Palm Beach Road face the creek and take the salt wind. A bathroom window left open lets that air in all day.
Plain steel hinges and brackets rust in a year or two in that air. We use stainless steel fittings on every enclosure here. Rust stains on tiles are hard to remove once they start.
The silicone seal also needs a day to cure before the shower is used. In humid weather we ask for a little longer. A seal that sets wet fails early.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















