A shower enclosure in Colaba is usually one of two jobs. In the old low-rise blocks the bathroom is small, the walls are thick, and a fixed glass panel is often the whole answer. In the towers of Cuffe Parade the bathroom is larger and a full cubicle fits. In both, the sea is close, and the humidity in this part of Mumbai decides the fittings we use.
A single fixed panel for a small Colaba bathroom
Bathrooms in the old blocks off Colaba Causeway were built small. A full cubicle with a door often leaves no room to stand. So we usually suggest one fixed glass panel at the end of the shower.
The panel stops most of the spray. The open side lets you walk in. There is no door to swing, and no track to clean. In a narrow room this is the more useful answer, not the cheaper one.
We set the panel on a slim wall profile and a floor bracket. The wall profile hides a wall that is not quite straight. Old plaster rarely is. The glass is toughened safety glass, so a knock against it in a tight room is not a risk.
Hinges that live with sea humidity
Colaba bathrooms stay damp for most of the year. The monsoon is long, and the sea breeze carries salt in through the window. A shower hinge sits in that damp all day.
So we fit stainless steel hinges and brackets, and we ask for the grade that resists salt. Chrome plating over cheaper metal looks the same on day one. By the second monsoon the plating bubbles and the metal under it rusts.
The glass itself does not mind the salt. The silicone seal does not either. It is only the metal, so the metal is where we spend the money. We say this at the survey, so the quote is clear about why.
Cubicles in the Cuffe Parade towers
A Cuffe Parade tower flat usually has a larger bathroom, often with a window toward the sea. Here a proper cubicle fits: two glass sides, a hinged or sliding door, and a tray or a tiled fall to the drain.
The towers have service lifts, so a tall panel reaches the floor in one piece. We still check the turn from the lift to your door. A long corridor with a tight corner can stop a panel that the lift took easily.
The building office sets hours for noisy work. Drilling the wall brackets is the only noisy part, and it takes a short while. We do it inside those hours and finish the quiet work after.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















