Parel's towers house two kinds of family. Those who moved from the chawls into rehab flats in the same project, and those who bought the sale flats above. The rehab bathrooms are small. The sale bathrooms are larger. Around Lalbaug and Sewri, older buildings have bathrooms added or changed over time. In every case the ask is the same: a bathroom floor that stays dry outside the shower. We fit shower glass across this part of Mumbai.
One fixed screen for a rehab flat in Parel
A rehab flat bathroom holds the shower, the WC and the basin in one small wet room. Water from the shower reaches everything. A full cubicle would leave no room to move.
A single fixed glass screen solves most of it. It stands beside the shower on a slim profile and a floor bracket. Spray stays on the shower side. The WC and the floor outside stay dry.
The glass is toughened safety glass, so a knock in a tight room is no risk. The fitting takes a short while, and the bathroom is back in use once the silicone sets overnight. It is the smallest job we do, and one of the most useful.
The sale flats above, and their shower kerbs
The sale flats in the same towers have bigger bathrooms with a shower area marked by a kerb. The builder leaves the glass to the owner. The walls are new and mostly straight.
We check the kerb with a level before cutting any glass. Kerbs are often a little out, and a panel on a sloping kerb shows a tapering gap at the base. Where it is out, a slim channel hides it.
Then we fit a hinged door on a fixed panel, or a sliding door if the room is long and narrow. Stainless steel hinges and a proper door seal. We suggest a clear panel, because frosted glass makes a small room feel smaller.
Older bathrooms around Lalbaug and Sewri
The older buildings of Lalbaug and Sewri have bathrooms that have been changed over the years. A window where the glass should go. A wall that is not square. A floor that falls away from the drain.
We measure every wall and we run a little water to see where it goes. The enclosure goes where the water runs. A frameless panel against a leaning wall opens a gap, so we use a slim wall profile where the level says to.
Sewri is near the docks and the air carries salt. Stainless steel hinges and brackets do not spot there. The glass and silicone are not affected. The lifts are small or absent, so the panels go up the stairs, and we measure the turn first.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















