Homes in Lower Parel are mostly new. Towers have risen on the old mill lands along Senapati Bapat Marg and toward Currey Road. The bathrooms in them are larger than most of Mumbai's, and many came with a shower enclosure fitted by the builder. A lot of our shower work here is replacing that first enclosure, or adding glass where the builder left a bare shower area.
Replacing a builder-fitted shower enclosure
A new tower flat often comes with a shower enclosure chosen by the builder. It looks fine on handover. After a few years the hinges sag, the seals leak and the door scrapes the tray.
We remove the old enclosure and look at what it left behind. Old silicone, holes in the tile and sometimes a damaged kerb. We clean the silicone off, fill or reuse the holes, and check the kerb with a level.
Then we fit a new enclosure made to the real opening. Thicker toughened glass, stainless steel hinges and a proper door seal. The difference is in the fittings, which is where the first one failed.
A large bathroom with a bare shower area
Some flats are handed over with a shower area marked by a kerb or a step, and no glass. Large bathrooms here let us do more than a single screen.
We can build a walk-in shower with a fixed panel and an open end. Or a full cubicle with a hinged door. Or a glass wall across the room with a sliding door. That splits a long bathroom into a wet half and a dry half.
Which one depends on where the drain is, where the window is, and how the room is used. We draw the options on the survey. The glass is toughened and the fittings are stainless steel in every case.
Fitting inside a Lower Parel tower
Towers here run strict building offices. They need a work permit, the names of our fitters, a service lift booking and set hours for noisy work. We handle this before the fitting day and send you the list.
Drilling the wall brackets is the only noisy step and it is short. We do it in the permitted hours. Glazing and sealing are quiet and continue after.
Senapati Bapat Marg traffic is heavy for most of the day. We deliver in the morning window through the service entrance. The glass is protected in a padded frame on the way through the lobby and the lift.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















