The housing societies around Shivaji Park and Hindu Colony are old walk-up buildings. The bathrooms are small, the walls are thick, and there is usually no lift. Some of these buildings have been rebuilt as towers, with bigger bathrooms and a service lift. We fit shower glass in both kinds of Dadar home, and the building you are in decides most of what we do.
The small bathroom in a Shivaji Park walk-up
An old society flat near Shivaji Park has a bathroom built for a bucket and a tap. The shower came later, and it wets the whole room. A full cubicle would not leave space to turn around.
We usually fit a single fixed glass screen, or a fixed panel with a sliding door. Neither needs floor space to swing. The screen keeps the spray in one half of the room and the other half dries out.
The walls are thick and often not square. We put a level on them and use a slim wall profile where they lean. The profile takes up the difference. Frameless glass against a leaning wall opens a tapering gap, and we would rather tell you that first.
Carrying glass up a Dadar society stair
Most of these societies have no lift. The glass goes up the stairs by hand. The stair is narrow and turns at each floor, and the turn sets the longest panel that will fit.
We measure the turn before the glass is ordered. Toughened glass cannot be cut once it is made. If one tall panel will not go round, we make the side as two panels with a slim joint.
The society sets hours for work and for carrying material. We ask the secretary for them and we keep to them. The stair and the landing are protected with boards while the panels go up.
Bigger bathrooms in the rebuilt towers
Where an old society has been rebuilt as a tower, the flats have larger bathrooms with a shower area marked by a kerb. The walls are new and straight and there is a service lift.
Here a proper cubicle fits: a fixed panel, a hinged door and stainless steel hinges. We check the kerb with a level before cutting the glass, because a sloping kerb shows a gap at the base.
The tower's building office sets hours for noisy work. Drilling the brackets is the only noisy part and it is short. We do it inside the hours and finish the quiet glazing after. Dadar's humid monsoon is the same for both buildings, so the fittings are stainless steel in both.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















