Baner gives us two kinds of repair. Along Baner Road and Pancard Club Road, the cafe and shop doors work all day and start to slam or stick. In the towers behind, new flats show their first-year faults: a slider not set level, a uPVC handle loose, a seal that does not meet. Both kinds are small. Both are done in one visit when we know what to bring. Send a photo and we usually do.
A Baner Road cafe door that slams or drifts
A glass door on a floor spring should close itself and stop quietly. When the spring wears, the door slams. When the clamps slip, it drifts and stays open. Both happen on Baner Road, where a cafe door opens all day.
We reset the spring's speed and check its clamps. If the spring has failed, we replace it with one rated for a busy door. The glass is not touched.
We do this before the cafe opens or in the slow hour after lunch. The door is out of use for about an hour. The cafe keeps trading through the side door or stays open with the main door propped.
Setting new sliders and uPVC windows right in a Baner tower
The sliding doors and uPVC windows in a new Baner flat were fitted during the building's fit-out. They were fitted quickly, by somebody working through hundreds of them.
So a slider may sit a few millimetres off level. It runs, but it rubs at one end. A uPVC handle may have been tightened by hand and now spins loose. A window seal may not meet along one edge.
We go through the flat and adjust each one. The slider is set level on its rollers. The handle is fixed with its proper screw. The seal is reset in its channel. One visit, every opening, and the flat is as it should have been handed over.
Broken shopfront glass on Pancard Club Road
A shopfront pane breaks from a knock, a stone or a stress crack that spread. On Pancard Club Road the shop has to keep trading, and the pavement has to be safe.
We clear the broken glass and board the opening on the first visit. Then we make a new toughened pane to the exact size. Toughened glass is cut first, then heated to make it strong, so nothing can be changed after. It takes a few working days.
On the second visit we fit the new pane and take the board away. If the old glass was plain, we suggest toughened for the new one. A shopfront should be safety glass.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































