The homes behind JM Road, in Model Colony and the lanes of Shivajinagar, are older flats and houses. Their bathrooms were usually tiled once when built and again at a later renovation. That second layer of tile changes how a shower enclosure sits. We measure the real wall, not the plan, and we choose the style for that wall.
Shower glass on a Model Colony tiled ledge
Many of these bathrooms have a low tiled ledge around the shower corner. The ledge was built to hold a curtain rod or a half wall. A glass enclosure can sit on it.
We check two things first. Is the ledge level along its length? And does the tile on top slope to the drain? A glass panel wants a flat seat. Where the ledge slopes, we set the channel in silicone and pack it level before the glass goes in.
If the ledge is cracked or loose, we say so. Glass on a loose ledge works loose with it.
Walls tiled over old tile
A wall tiled twice is thicker than it was, and rarely by the same amount at both ends. So the two walls of a shower corner are often not square to each other.
Frameless glass needs a square corner, or a gap shows at one end. A slim aluminium frame hides a small difference inside its channel. For a corner that is out by more than the channel allows, we make the fixed panel to the shape of the wall.
We check this with a square and a level at the measuring visit. It takes a few minutes and settles which style you should have.
Hard water marks on the glass
Pune's corporation water is soft, but a Shivajinagar home that tops up from a borewell gets hard water. Hard water leaves white marks on glass when it dries.
So we offer a protective coating on the inside face of the glass. Water runs off it in sheets instead of drying in drops. The marks come much more slowly, and a wipe removes them.
For the fittings, we pick stainless steel hinges and handles. Plated fittings lose their shine faster under hard water drops. A rubber blade on the door edge also helps, because it stops the drops sitting on the glass.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















