Shivajinagar gives us two kinds of repair call. From JM Road and FC Road it is a shop or cafe door that has stopped closing well. From Model Colony and the lanes behind it is a window, a mesh or a shower hinge in an older Pune home. Both are usually a worn part, and rarely the glass itself.
Shop doors on JM Road and FC Road
A glass shop door here opens from morning to late evening. The floor spring under it does the closing. When it wears, the door slams, swings too far, or stops short of the frame.
We change the floor spring for one rated for the weight of the door. We reset the door so it hangs straight and the lock meets its keep. The glass stays.
A shop front panel that has cracked at a corner cannot wait. The crack runs with every door slam. We make the opening safe the same visit and measure for the new panel.
Sliding windows and mesh in the Model Colony homes
The older flats of Model Colony have aluminium sliding windows that have run for many years. The rollers under the shutter wear flat, and the window drags or jumps the track. New rollers and a clean track usually cure it.
The mosquito mesh in these frames is often torn or gone. We make a new mesh shutter to the frame. In an old frame with no mesh track, we fit a mesh frame on the inside of the window.
Pune's dry season brings dust in through every gap. A new rubber on the shutter edge seals that gap and quiets the rattle too.
Glass that cracks in the Shivajinagar sun
A west-facing shop front on FC Road takes full afternoon sun. Glass that is held too tight in its frame, or that has a small chip at the edge, can crack as it heats and cools.
When we replace a panel like this, we leave the right gap in the frame for the glass to move. We use a soft setting block under it. A toughened panel takes heat far better than ordinary glass.
For a cracked mirror in a salon or a home, we measure and replace the same way. We take the old glass away with us.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































