An office in the Rajiv Gandhi Infotech Park runs on glass doors. Every one of them has a closer, a lock and a card reader, and hundreds of people pass through them a day. When a closer fails, the door slams all day. When a partition panel cracks, the floor has a hazard in it. When a lock misses, the card reader is blamed. We fix all three in Hinjewadi, usually outside your working hours.
Overhead door closers that slam on a Hinjewadi office floor
Most office glass doors in the park hang on hinges with an overhead closer, the arm at the top that pulls the door shut. Closers have two speed settings. When they drift, the door either slams or will not latch.
We adjust both speeds first. If the closer has lost its oil, it cannot be adjusted and we replace it with one rated for the door's weight and traffic.
A door that has been slamming for months has usually loosened its hinges too. We check and retighten them on the same visit. The slam stops, and the door latches without being pushed.
Replacing a cracked partition panel over the weekend
A partition panel on an open floor cracks from a trolley, a chair or a knock while moving furniture. Toughened glass holds together when cracked, but it is not safe to leave and it looks bad in a client area.
We measure the panel on a weekday visit and have a new one made. It is fitted on Saturday, when the floor is empty. The old panel comes out, the new one goes in, and the silicone cures before Monday.
If the panel carried a logo or a frosted band, we match it. We also bring the gate pass paperwork in order, because the park's security will not let glass through the gate without it.
Glass door locks that must work with the access control
An office door in Hinjewadi locks electrically. A card reader releases a strike or a magnetic lock, and the door must sit exactly right for them to engage.
When a door drops a few millimetres, the strike misses and the door stays unlocked, or the magnet does not hold. The access control gets blamed. The fault is in the door.
We reset the door on its hinges or patch fittings so it sits true in its frame. Then we align the strike plate or the magnet to the door's new position. Your access control vendor does not need to come. The lock works again because the door does.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































