Repairs in Bandra West follow the sea. The closer a flat is to Carter Road or Bandstand, the faster its window fittings wear. Aluminium pits, rollers rust, locks stiffen. Further in, around Hill Road, the problems are the ordinary ones of old Mumbai housing. Wooden frames that swell, mesh that tears, glass that cracks.
Rusted rollers and pitted aluminium on the sea face
A sliding window near the sea becomes heavy to move within a few years. The rollers underneath have rusted, and the track is pitted. Salt does this to plain steel and to untreated aluminium.
We replace the rollers with stainless or nylon ones that salt does not touch. We clean the track and, where it is badly pitted, fit a track cover.
The frame itself is usually fine. Pitting on the surface looks bad but rarely goes deep. So the repair is the moving parts, not the window. That is a far smaller job than a new window.
Wooden windows that will not shut in the monsoon
Older flats around Hill Road and Pali Hill still have wooden windows. From June the wood swells with the damp and the shutters jam or will not close.
We adjust the hinges and the stop so the shutter closes, and seal the wood so it takes up less water next year. Where a frame has rotted at the bottom, we tell you, and offer an aluminium or uPVC window in the same opening.
If you want to stop the yearly problem for good, a uPVC or aluminium window in the same opening is the answer. We can fit one without changing the look of the building from outside.
Fitting mosquito mesh in an old Bandra flat
Old Bandra West buildings have gardens, trees and open drains close by. Mosquito mesh on the windows is the usual request, and the old frames make it harder than it sounds.
A sliding mesh shutter needs a track. Old wooden or steel windows do not have one. So we fit a slim aluminium frame inside the opening and run the mesh shutter in that.
We use stainless or fibreglass mesh here, not plain steel. Steel mesh rusts within a season this close to the sea. The mesh frame is removable, so you can take it down to clean it.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































