The societies of Katraj, Ambegaon and Narhe climb the slopes at the southern edge of Pune. Their bathrooms were tiled by many different hands, and the floors fall in many different directions. A shower enclosure sits on that floor. If the floor falls away from the drain, the enclosure has to be planned so the water still ends up where it should. That planning is most of what we do in Katraj.
A Katraj bathroom floor that falls away from the drain
A shower floor should slope gently to the drain. In many Katraj society flats it slopes somewhere else. Water runs to the door, or pools in a corner.
Glass cannot fix a floor. But we can place the glass so the low side of the floor is inside the enclosure. The water then stays behind the glass and finds the drain in its own time.
Where the fall is badly wrong, we tell you to have the tiler re-lay the shower floor before the glass. A fixed panel over a floor that drains outwards gives you a wet bathroom every day. We would rather say so than fit it.
Tanker water, borewell water and the marks they leave
Some societies on the Katraj and Ambegaon slopes take water from tankers for part of the year, and from borewells for the rest. The hardness changes with the source. One month the glass stays clear, the next it clouds.
We cannot change the water. We can make the glass easier to live with. A protective coating stops the drops drying into a hard film. The marks that do form come off with a mild acid cleaner, which we show you at the fitting.
The fittings matter too. Hard water leaves deposits in a hinge. We use fittings with a sealed finish that wipe clean, rather than a plated one that pits.
Carrying glass up a society stair in Narhe
Most of the older societies of Katraj and Narhe have stairs, not lifts. The buildings sit on a slope, so the ground floor on one side is the first floor on the other.
We measure the stair on the same visit as the bathroom. The turn at each landing sets the largest panel we can carry. If one panel is too big, the fixed side comes as two with a slim joint.
We also look at where the van can stop. Society lanes on the slope are narrow and steep. We park where the gate lets us and carry from there, which is one more reason the measuring visit is done in person.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















