
Table tops and mirrors · Bengaluru, Delhi NCR, Mumbai MMR and Pune
Bathroom Mirror Broken? Causes & Repair Cost
A cracked mirror cannot be mended, but a new one made to the same size is a quick job.
₹416/ sq ft starting price₹52020% off
The starting price for Mirror & Custom Glass Installation, the commonest fix. You pay this rate for the square feet we measure on site.
- Verified on-site measurement
- 2-year product warranty, 6 months on the work
- Fitted by our own team. We never subcontract.
The short answer
A bathroom mirror usually cracks because a screw was tightened too hard or the wall behind it moved. A chipped edge that finally ran is the other common cause. A wardrobe mirror cracks when the shutter twists on worn rollers or a clip presses on the glass. Mirror glass cannot be repaired, so we make a new mirror to the same size and fit it. In a damp room we use copper-free mirror, which resists black edges.
The useful distinction
Where the crack began says what moved the mirror
A crack from a screw hole usually means a fixing was tightened too hard. A crack across the middle of a glued mirror points to movement in the wall. A wardrobe mirror cracked near a clip points to the shutter moving.
Why it happens
Usually one of these 4 things, commonest first. Each one says how to tell, and what we do about it.
A screw or cap was tightened too hard on the mirror
- How to tell
- The crack runs out from a fixing hole in a corner. Mirror caps are the small round covers over screws at each corner. Tightened past snug, the screw presses the glass against the wall until it splits.
- What we do
- We make a new mirror with the holes drilled before fitting. Each screw gets a rubber washer and is turned only until the mirror stops moving. Where the wall suits it, we use clips instead of screws.
Mirror & Custom Glass InstallationFrom ₹416 / sq ftSee this fixThe wall or tile behind a glued mirror has moved
- How to tell
- The mirror was stuck straight to the tiles with no screws. A crack crosses the middle, and a tile behind it may sound hollow when tapped. Walls move a little with heat and damp, and glued glass cannot.
- What we do
- We fit the new mirror on neutral-cure silicone, a sealant that stays soft and does not harm the backing. It is put on in dabs, so the mirror can move a little with the wall. A hollow or cracked tile is a tiling job, not ours.
Mirror & Custom Glass InstallationFrom ₹416 / sq ftSee this fixA chip at the edge has run into a crack
- How to tell
- The crack starts at the edge or at a corner and runs inward. You may remember a knock from a tap, a bottle or a cleaning bucket. A mirror edge that was never polished chips more easily.
- What we do
- The new mirror gets polished edges, which resist chipping. We measure the space and make it to the same size, or a new size if you want one.
Mirror & Custom Glass InstallationFrom ₹416 / sq ftSee this fixThe wardrobe shutter twists, and the mirror cracked on its clip
- How to tell
- A mirror on a sliding wardrobe shutter cracked near a clip or along the edge strip. The shutter may drag, rock or jump its track. A shutter that twists as it moves bends the mirror a little every day.
- What we do
- We fit new mirror to the shutter and look at why it twisted. Worn rollers, the wheels under the shutter, or a bent track usually explain it. We change those at the same visit so the new mirror is not strained.
Wardrobe Sliding Door RepairFrom ₹1,710See this fix
What you can check first
These checks are safe to do yourself. A photo or a short video of what you find helps us come prepared.
- Find where the crack starts: a corner screw, the middle, an edge, or a wardrobe clip.
- Tap the tiles around a glued mirror and listen for a hollow sound.
- Slide a wardrobe shutter slowly and notice whether it rocks or drags.
- Measure the mirror's width and height, so we can quote before the visit.
Do not pull a cracked mirror off the wall yourself. Mirror glass is not toughened, so it breaks into long sharp pieces that can fall as one sheet. Keep children away from a cracked wardrobe shutter until it is changed.
What the repair costs
Every fix on this page, with its starting price before GST. We find which one you need, and you get a fixed price before any work starts.
| Fix | Starting price | How it is priced | Link |
|---|---|---|---|
| Mirror & Custom Glass Installation | ₹416/ sq ft | You pay this rate for the square feet we measure on site. | See this fix |
| Wardrobe Sliding Door Repair | ₹1,710 | One visit covers travel and the work to fix the fault. Any parts are priced on their own line. | See this fix |
Not sure which one it is? Send a photo or a short video. We will tell you what it looks like, usually within minutes, before anyone comes out.
Chat on WhatsAppA photo or a video is enough to startCommon questions
My bathroom mirror cracked on its own overnight. What could have done that?
Usually a screw that was too tight, or a wall that moved with heat and damp. A tiny chip at the edge can also run weeks after the knock that made it. Nothing about the mirror itself makes it break without a cause.
Can a cracked mirror be glued or filled so the line does not show?
No. The crack goes through the silver backing as well as the glass. Any filler shows as a dark line in the reflection. The honest fix is a new mirror cut to the same size.
Does a wardrobe mirror need a special kind of glass?
It needs a thickness that suits the shutter and a safety backing film. The film holds the pieces together if the mirror ever breaks on a moving door. We fit mirror made for shutters, not plain wall mirror.
What is copper-free mirror, and do I need it?
Ordinary mirror has a copper layer behind the silver, and damp turns it black at the edges. Copper-free mirror leaves that layer out, so it lasts longer in a bathroom. For a dry bedroom wall, ordinary mirror is usually fine.
Related problems
Other problems with the same kind of door, window or fitting, and where to go next.
Table tops and mirrors
Same fixes, other problems
Get it fixed at your place
We come to you anywhere in Bengaluru, Delhi NCR, Mumbai MMR and Pune. We find the cause, and give you a fixed price before any work starts.
- Toughened safety glass, at the thickness stated in your written quote.
- The fittings, finish and supplied parts are named before you approve the job.
- We source the glass and fittings against the specification in your written quote.
- We check the quality before we leave. Most jobs are done in 3 to 4 days.
- No hidden fees. GST is shown as its own line on the quote.
- Your details stay protected and confidential on a secure connection.
- You get dedicated support after fitting, from the same team every time. They are dependable.
- Easy and transparent from the first message. We work customer-first, so the job stays hassle-free.