Bathrooms in the Kamothe societies are often square rather than long. The shower is in one corner, and the rest of the room does the washing, the bucket and sometimes the machine. A corner enclosure is the usual answer in Kamothe. Two sides of glass, a door on the diagonal or on one side, and the rest of the floor dry.
A corner enclosure for a square Kamothe bathroom
A corner enclosure uses the two tiled walls as its back. We add two glass sides to make the box, with the door in one of them.
A hinged door on the longer glass side opens into the room. Where the floor is tight, a sliding door runs along the glass instead. A door set across the corner at an angle saves the most floor but gives the smallest opening.
We mark all three on your floor with tape at the measuring visit. You step into each and choose the one that feels right.
Keeping the bucket corner and the machine dry
In many Kamothe flats the washing machine stands in the bathroom. Spray from an open shower reaches it every day, and that is how a machine rusts.
The corner enclosure stops that. We set the glass line so the machine, the bucket corner and the basin are all on the dry side.
The floor on the dry side still has a drain. We make sure the enclosure's bottom seal does not block the fall to it. A dry floor that cannot drain is a wet floor by evening.
Dust from the highway, and the glass finish that hides it
Kamothe runs along the Sion-Panvel highway and the dust from it reaches every open window. In a bathroom it settles on wet glass and dries as a grey film.
Frosted or textured glass hides that film far better than clear. A water-repellent coating helps too. We suggest frosted for the lower half at least, which also gives privacy.
The fittings are stainless steel. Highway dust is gritty and gets into hinges, so we fit hinges with covered pins that grit cannot reach.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.















