The flats of Ulwe are new, but the sector around them is a building site. Cement splashes land on glass and frames from the tower next door. Grit works into sliding tracks within weeks. And the windows themselves were fitted fast, with gaskets cut short and locks sometimes missing. Our repair work in Ulwe is about making a new window as good as it should have been.
Cement and plaster splashes on new glass in Ulwe
Wet cement that lands on glass and dries bonds to it. Scraping it off with a blade scratches the glass. Left for months it etches a mark.
We remove it with a cleaner made for the job and a plastic scraper, then polish the glass. Splashes on the aluminium frame come off the same way without marking the powder coat.
Where a splash has etched the glass, polishing takes most of it out. A pane that is badly etched is replaced. We tell you which it is before we start.
Grit in the tracks, and rollers that did not last a year
Construction grit is coarse and sharp. It fills the bottom track of a slider and the rollers grind over it. In Ulwe we see rollers flat within a year of handover.
We clean the track, fit rollers with sealed bearings that grit cannot enter, and add brush seals that sweep the track as the window moves.
Until the building next door is finished, the track still wants vacuuming now and then. We show you how. It takes a minute per window.
Short gaskets, missing locks and the builder's snag list
A builder's window team works fast. The rubber gasket around the glass is often cut a little short and leaves a gap at one corner. Rain finds it in the first monsoon.
We replace short gaskets with new ones cut to length. Where a lock or a handle was never fitted, we fit one that matches the rest. Keeps are adjusted so each lock engages.
We walk every window and door in the flat and list what is wrong. Raise the list with the builder too if the flat is in its defect period. Either way, we fix it.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































