Fort mixes three kinds of door. The heavy timber and glass doors of the stone buildings in Ballard Estate. The glass shop fronts of the galleries and cafes around Kala Ghoda. And the tall glass entrance doors of the Nariman Point towers, used by thousands of people a day. We repair all three. In Fort the usual fault is a door, not a window.
Old timber and glass doors in Ballard Estate
The doors in the stone buildings are tall, heavy and often original. They have glass panes set in timber, brass hardware and large hinges. Over the years the hinge screws work loose in the old frame, and the door drops and scrapes the floor.
We do not replace a door like this. We lift it, plug the old screw holes with hardwood, and refit the hinges with longer screws. Where a glass pane has cracked, we cut a new pane to the exact size and bed it in the timber as before.
In the monsoon these doors swell and stick. Planing them while swollen leaves a gap in winter. We adjust the stop and the latch instead, and we seal the bare timber so it takes in less water.
Gallery and cafe shop fronts around Kala Ghoda
The streets around Kala Ghoda have galleries, cafes and small shops with glass fronts. The front is the shop. A cracked pane or a door that will not lock cannot wait for a week.
We come the same day where we can, clear the broken glass, and board the opening so the shop locks. The new pane is cut to the measured opening and fitted on the next visit. For a front on a busy pavement we fit toughened safety glass.
Many of these fronts use frameless glass doors on patch fittings. When the door drops or the lock stops catching, the patch fitting has usually loosened. We reset it and change the floor spring if the door no longer closes on its own.
Tower entrance doors on Nariman Point
A Nariman Point office tower has a glass entrance door that opens all day. The floor spring under it is a wear part. When the door slams, swings past the closed line or stops short, the spring has reached the end of its life.
We replace the floor spring with one rated for the door's weight and traffic. The building usually asks for this work after office hours. We do it in the evening and the door is back in service by morning.
Upstairs, the office floors have sliding glass doors and windows that face the sea. Sea air stiffens the rollers and pits the handles. We replace both with stainless steel parts, and the windows run quietly again.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































