The Worli Sea Face is where sea air does some of its worst damage in Mumbai. Sliding doors onto the balconies seize. Glass railing clamps rust and loosen. Window handles pit and stick. Further back, toward Annie Besant Road and Haji Ali, the problems are the same but slower. We repair sliding doors, windows, railings and glass across Worli, and we fit new windows made for this exposure.
Balcony sliding doors on the Worli Sea Face
A balcony door on the Sea Face is large, heavy and faces the wind. Salt and sand collect in the bottom track. The rollers grind, then seize. The door becomes hard to move, and the lock no longer meets its keep.
We strip the track, clean it, and fit new rollers rated for the door's weight. Stainless steel rollers last longer here than the standard ones. We also fit a brush seal at the meeting rail to stop the whistle in the wind.
We suggest a rinse of the track with fresh water after a storm. It takes a minute and it keeps the salt from drying into the rollers. The door then runs for years rather than months.
Glass railings that have loosened in the salt air
Many balconies here have glass railings. The glass is toughened and lasts. The metal does not. Clamps, posts and the top rail rust at the fixings, and the panel starts to move when pushed.
We replace clamps and fixings with marine-grade stainless steel. We reseal the base plates so water does not sit at the bolt. A cracked or chipped panel is replaced with toughened glass cut to the same size.
A moving railing on an upper floor is a safety call, and we treat it as one. We make the balcony safe first, often with a temporary brace, and quote the full repair after. Please keep children off the balcony until we have been.
Pitted windows and new windows built for the sea
Aluminium windows on the Sea Face pit on the surface within a few seasons. Handles stick and hinges rust. Owners often ask for new windows when the frame is still sound.
We replace the handle, the hinge and the hardened rubber, and the window works again. Pitting on the finish does not stop a frame doing its job. We clean and reseal it.
When the frame has corroded through at the corners, we fit a new window. For this exposure we suggest uPVC, which does not corrode, or a heavy powder-coated aluminium section with stainless steel hardware. We set the frame so rain blown into it drains out, not into the wall.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































