A godown in Bhiwandi, at the edge of Thane, keeps its dock doors open all day. Wind pours through the building and catches every glass and aluminium door inside it. Doors slam, frames bend and tracks fill with dust. Our repair work in Bhiwandi, Kalher and Mankoli is mostly about fitting parts heavy enough for that.
Office doors slammed by wind through the dock
When a godown's dock doors are open, the wind through the shed slams every cabin door that is not held. A door closer made for an office cannot hold it.
We fit heavy-duty closers with a strong backcheck, which slows the door before it hits the frame. On a glass door we fit a rated floor spring instead. A door stop on the floor saves the frame.
The hinges are replaced with stainless steel ones that take the shock. A door that has slammed for a year has usually loosened its hinge screws too.
Bent aluminium frames and dusty sliding tracks
A sliding aluminium door or window in a godown office gets hit by trolleys and bales. The frame bends and the panel will not slide.
We straighten a bent section on site where we can. Where it has kinked, we replace that one section and keep the rest. The track is cleaned of dust and a stainless insert goes over a worn one.
New rollers go in, and a brush seal on the panel edge slows the dust getting back into the track. We show the staff how to vacuum it.
Broken panes in a cabin on a working floor
A pane in a godown cabin breaks when goods swing into it. The cabin is then open to the dust and the noise until it is fixed.
We clear the glass and board the opening on the first visit. New toughened glass is cut to size and fitted on the next. The gasket around it is replaced so the cabin seals again.
Where the same pane breaks often, we suggest a guard rail on the floor side. It is cheaper than a third pane. Laminated glass is another answer where people stand close.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































