Flats in Hiranandani Estate and Brahmand have tall french windows onto the balcony and glass railings outside them. Both are well made. Both have moving parts that wear with years of use. We repair those parts across the estate and down to Waghbil, in Thane.
French windows that no longer slide or lock
A french window is a tall sliding glass door the full height of the room. It is heavy, and it runs on rollers no bigger than a coin.
When the rollers wear, the door drops and the lock no longer meets its keep. People push harder and the handle breaks. We fit new rollers rated for the glass weight and lift the door back to level.
The lock then lines up again. If the handle has cracked, we fit a new one in the same finish. The glass and the frame are not touched.
Glass railing clamps on a Patlipada balcony
The balcony railings here are glass panels held in stainless clamps or a base channel. After years of rain the gaskets inside the clamps harden and the panel can rock.
We replace the gaskets and re-tighten each clamp to the right torque. Bolts into the slab are checked for rust. Where a clamp has lost its finish and pitted, a new one goes in.
A panel with a chipped edge is replaced. Toughened glass cannot be repaired at the edge. The new panel is cut to the same size and set in the same clamps.
Entrance doors and closers across the estate towers
Each tower in the estate has a glass entrance door and inner lobby doors. They swing hundreds of times a day.
The closer wears first. The door starts to slam, or stays open and lets the rain in during the monsoon. We fit a closer rated for the traffic and set it so the door shuts gently and latches.
We can do several towers for a society on one visit. Tell your society office to list every door that misbehaves, and we price the visit as one job.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































