An office entrance door in a CBD Belapur block opens hundreds of times a day. It is the hardest-worked glass in Navi Mumbai. The floor spring tires first, then the patch fittings loosen, and then the door drops and scrapes. Most of our repair calls here are that door. The rest are a broken lobby pane and the access control that someone wants fitted onto glass.
The floor spring under a busy Belapur office door
A glass entrance door turns on a floor spring set into the floor. Inside it is oil and a piston that controls the closing speed.
With hundreds of openings a day the oil leaks within a few years. The door then swings free and bangs. Or it stops closing fully and the air conditioning leaks out all day.
We lift the door off, change the spring unit and set the speed. The pivot is reset so the door no longer scrapes. The job is done before the office opens, or after it closes.
Patch fittings and the door that has dropped
The glass door is held at its top and bottom corners by patch fittings. These are metal clamps with a rubber gasket inside.
The gasket compresses over time. The glass slips a few millimetres in the clamp. The door drops at the handle side and catches the floor or the frame.
We re-set the glass in the fittings with new gaskets and torque the bolts correctly. If a fitting has cracked, we replace it. The door hangs true again without any new glass.
Access control on a glass door, and broken lobby glass
Offices in Belapur often add card access after moving in. The lock plate must sit on toughened glass, which cannot be drilled after it is made.
So we fit an electromagnetic lock to the frame and a clamp-on plate to the glass. No holes. The reader goes on the wall beside the door.
A broken pane in a lobby is made safe the same day. We clear the glass, board the opening and measure. The new toughened pane follows in a few days and is fitted outside office hours.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.























































