Almost every office we work on in Indiranagar used to be a house. That is the main point. The rooms are already split up. The ceiling height changes as you walk through. And there is usually a beam right where the glass needs to go. None of this is hard. But it means we measure the real room, not a drawing.
How a cabin is built in a converted house
We make each panel for its own room. We do not use one size for all. In most of these buildings the ceiling drops down between rooms. Where it drops, we make the glass follow it.
Floors here often slope a little. So we set the glass line from the finished floor, not from a straight line on the wall. If we did not, the top of the panel would follow the ceiling and the bottom would leave a gap.
We use toughened glass everywhere. Toughened glass is strong safety glass. We pick the thickness for the height of the panel and whether it holds a door. Clear full-height glass usually gets a frosted band at eye level. This is a simple safety step once people walk past it all day.
The staircase decides the panel size
Very few buildings here have a service lift. So we carry every panel up by hand. The staircase has a turn, and the panel must fit around it.
We measure that turn on the same visit as the room. People never think of it. But it matters more than the door opening does.
When one panel is too big for the turn, we make the run as two panels. We join them with a slim connector. From a few feet away you cannot see the join. But we will not force a toughened panel around a corner. When toughened glass breaks, it breaks fully. And a made-to-size panel cannot be bought off the shelf.
Delivering onto an Indiranagar cross
The crosses are narrow and cars park on both sides. A vehicle standing outside your building causes trouble within minutes.
So we deliver early. We unload straight away. Then we move the vehicle away before we carry the panels up.
Tell us your cross number and which floor you are on when you first call. It sounds like a small thing. But it decides how many people we send and what time we start.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you backUsually the same day. Where we can, we give you a rough price on the call. Then you know if a visit is worth your time.
- We come and measureWe measure the opening. We also check the walls, floor, ceiling and the way in. Your glass is made to these final sizes, so they must be right.
- You get a written priceIt shows the glass, the fittings and the fitting work as separate lines. If anything about the job changes, we tell you before we go ahead.
- We make it and fit itYou approve the price and pay the advance. Then we make your glass. Our team delivers it, fits it, checks the doors line up and clears the site.
