At your location in just 29 minutesGet the measurements right away.T&C

Illustration: An aluminium window shut against a dirt-packed lower frame joint

Windows · Bengaluru, Delhi NCR, Mumbai MMR and Pune

Window Stuck Shut? Causes & Repair Cost

A window that will not open is held by its frame, its rollers or its lock. Forcing it breaks the glass.

₹1,350 starting price₹1,50010% off

The starting price for Window Not Closing Repair, the commonest fix. One visit covers travel and the work to fix the fault. Any parts are priced on their own line.

  • Verified on-site measurement
  • 2-year product warranty, 6 months on the work
  • Fitted by our own team. We never subcontract.
Also searched as

The short answer

A window stuck shut has usually dropped and now binds against its frame. On a sliding window, rollers that have collapsed or rusted hold the shutter down. A channel packed with dirt or standing water after the monsoon does the same. On uPVC, the lock points can stay engaged even though the handle turns. Do not hammer the frame or lever the shutter, because the glass goes first.

The useful distinction

Find whether the lock or the frame is holding the window

Turn the handle first and watch the lock points on the frame edge. Points that stay put mean the lock is holding the window, not the frame. Points that move while the shutter stays tight mean it has dropped or seized. A sliding shutter that will not budge is usually sitting in a blocked channel.

Why it happens

Usually one of these 4 things, commonest first. Each one says how to tell, and what we do about it.

  1. The shutter has dropped and binds in the frame

    How to tell
    The handle turns and the lock is free, but the window will not open. One corner sits tight against the frame, and there is a gap at the opposite corner. It opened well until the shutter settled lower.
    What we do
    We square the shutter in its frame, on its hinges or its rollers. Then we set the keepers so the lock lines up. The window opens with one hand again, and we check it closes square too.
    Window Not Closing RepairFrom ₹1,350See this fix
  2. The rollers have collapsed or rusted and hold the shutter down

    How to tell
    The sliding shutter sits low at one end and will not move. Rusty streaks run along the channel, the Indian word for the track the shutter runs in. The shutter may have been getting heavier for months.
    What we do
    We lift the shutter out and fit new rollers, the small wheels under it. We reset its height so it runs level in the channel. The old rollers and the rust come out with us.
    Aluminium Window Roller ReplacementFrom ₹808 / pairSee this fix
  3. The channel is packed with dirt or standing water

    How to tell
    The window last opened before the monsoon. The channel is full of mud, leaves or water that did not drain. The shutter moves a little and then stops dead.
    What we do
    We clear the channel to the metal and open its drain slots. Then we check the rollers for damage from running in grit. The shutter is set back in and slid end to end.
    Sliding Window RepairFrom ₹1,350See this fix
  4. The uPVC lock points stay engaged while the handle turns

    How to tell
    On a uPVC window, the handle turns but the window stays locked shut. The lock points along the frame edge do not move with it. The gearbox behind the handle has stripped, so the handle turns in nothing.
    What we do
    We release the lock points from the frame edge without damage. Then we fit a new handle and gearbox, the case the handle spindle turns inside. The window opens, and we check every lock point moves.
    uPVC Window Handle ReplacementFrom ₹595 / handleSee this fix

What you can check first

These checks are safe to do yourself. A photo or a short video of what you find helps us come prepared.

  • Turn the handle gently and watch whether the lock points on the frame edge move.
  • Look along the closed shutter for a corner that sits tighter than the others.
  • On a sliding window, look into the channel for mud, leaves or standing water.
  • Do not hammer the frame or lever the shutter with a screwdriver.
  • Take a photo of the whole window and a close one of the channel or the lock edge.

Do not force a window that will not open. A shutter levered against its frame cracks the glass, and a sliding shutter can jump out of its channel. Leave it shut until it has been looked at.

What the repair costs

Every fix on this page, with its starting price before GST. We find which one you need, and you get a fixed price before any work starts.

FixStarting priceHow it is pricedLink
Window Not Closing Repair₹1,350₹1,50010% offOne visit covers travel and the work to fix the fault. Any parts are priced on their own line.See this fix
Sliding Window Repair₹1,350₹1,50010% offOne visit covers travel and the work to fix the fault. Any parts are priced on their own line.See this fix
Aluminium Window Roller Replacement₹808/ pair₹95015% offOne fixed price per pair, supplied and fitted.See this fix
uPVC Window Handle Replacement₹595/ handle₹70015% offOne fixed price per handle, supplied and fitted.See this fix

Not sure which one it is? Send a photo or a short video. We will tell you what it looks like, usually within minutes, before anyone comes out.

Common questions

How do I open a window that is jammed shut without breaking it?

Turn the handle fully and try the shutter with a steady push, not a shove. If it does not move, stop there. Hitting the frame or prising the shutter with a tool is how glass breaks. We free it by finding what is holding it.

Why won't my uPVC window open even though the handle turns?

The gearbox behind the handle has stripped, so the lock points stay in the frame. The handle moves, but nothing moves with it. We release the points from the frame edge and fit a new handle and gearbox.

My sliding window got stuck after the rains. Is that the rollers?

Usually the channel first. Monsoon mud and water pack the channel, and the shutter sits in it. Rollers that have run in grit for a season may also be worn. We clear the channel, then check the rollers before we change anything.

Is a window stuck shut the same as a window that will not stay open?

No. A window that drops shut on its own has lost the stay that holds it. That fault has its own page. A window stuck shut will not open at all. Our window not closing repair page covers both a window that will not shut and one that will not open.

Related problems

Other problems with the same kind of door, window or fitting, and where to go next.

Get it fixed at your place

We come to you anywhere in Bengaluru, Delhi NCR, Mumbai MMR and Pune. We find the cause, and give you a fixed price before any work starts.

  • Toughened safety glass, at the thickness stated in your written quote.
  • The fittings, finish and supplied parts are named before you approve the job.
  • We source the glass and fittings against the specification in your written quote.
  • We check the quality before we leave. Most jobs are done in 3 to 4 days.
  • No hidden fees. GST is shown as its own line on the quote.
  • Your details stay protected and confidential on a secure connection.
  • You get dedicated support after fitting, from the same team every time. They are dependable.
  • Easy and transparent from the first message. We work customer-first, so the job stays hassle-free.
Chat on WhatsApp