The repair work here is not unusual on its own. The setting is. A consulting room with patients in the corridor. Or a bungalow with a floor somebody has just had restored. So how we work matters as much as the part we fit. Matching what is already there matters more than in a new building.
Matching a finish that is no longer sold
A hinge or handle may fail on an enclosure fitted years ago. The old finish may not be on sale any more.
We match how the part works and get as close as we can on the finish. Where the new part will not look the same, we say so plainly. On a black or brushed set, it is good to know this before we fit, not after.
If matching matters more than cost, changing the pair usually looks better than changing only the one failed part. We will say so, not fit one that stands out.
Working without leaving a mark
We cover floors and sheet off the work area before we open anything up. Tile dust spreads, and old wooden floors do not forgive it.
We drill tile with the correct bit at low speed. We set the fixing points away from tile edges where we can. If a tile is already loose or hollow behind, we point that out before we drill, not after.
The old glass or fittings leave with us the same day. We do not leave anything in a corridor or a garden for somebody else to clear.
Fitting a new uPVC window in a finished room
Changing a window in a finished room is mostly about the mess, not the glass. When an old aluminium window comes out, the joint between frame and wall opens with it. That is where the dust comes from, so we sheet the room first. The new uPVC window is made to the opening before we come. We seal its frame to the wall on both faces, and the old frame leaves with us.
In a Richmond Town consulting room facing the road, ask for double glazing in that window. That is two panes with a sealed gap, and it lets less traffic noise through.
Homes around Shanti Nagar need smaller work. A sliding window that drags gets new rollers, the small wheels it runs on. Every window can take a mosquito net whose mesh panel lifts out for cleaning.
How the job works
- Tell us about the jobSend a few photos, rough sizes and what you need. Use WhatsApp or the form. For a repair, a short video of the door moving helps a lot.
- We call you back in about 2 minutesWe confirm what you need and a time to visit. Where we can, we give you a rough price on the call.
- We come and measureWe measure the opening and check the walls, floor and ceiling around it. Anything made to size is made to these measurements, so they must be right.
- You get a written priceIt lists each item, with GST as its own line. If anything about the job changes, we tell you before we go ahead.
- We fit itYou approve the price and pay the advance. Our own team fits the work, checks that every door and window opens and closes properly, and clears up. Most jobs are done in 3 to 4 days.
