Is this the right service for your job?
Choose this for an entrance that opens on a sensor and closes behind each person, at a shop, clinic, office or hotel.
- If a manual glass door on a floor spring is enough for the traffic you get, see the Toughened Glass Shop Front. A shop front with a self-closing door costs a fraction and needs no power.
- If your existing door only needs to close itself again, see the Glass Door Closer Replacement. A new floor spring or closer makes a manual door close every time.
Single or double sliding leaves, and the fixed glass beside them
A single leaf slides to one side and suits an opening up to about four feet wide. A double door has two leaves that part in the middle and suits wider entrances and busier doors, because each leaf travels half the distance and the door opens faster.
Where the opening is wider than the doors need to be, fixed toughened glass panels fill the rest. The leaves slide in front of them. A full-height glass front with an automatic door in the middle is the usual shop or clinic entrance.
The glass is 10 mm or 12 mm toughened, clear or frosted, with a safety band or a logo film at eye level so nobody walks into a clean pane.
The operator: motor, sensors and safety
The operator is a motor driving a toothed belt inside the header. Carriages on the belt carry the leaves on rollers along a track. A controller sets the opening speed, the closing speed, how long the door stays open and how far it opens.
A microwave or infrared sensor on each side sees a person approaching and opens the door. Safety beams across the opening stop the door closing on anyone standing in it. If the door meets a push while closing, it reverses.
The controller has modes for the day: open both ways, exit only, held open, and locked. A battery backup can keep it working through a power cut, or hold it open or closed, whichever is safer for the building.
Where automatic doors are fitted
At the front of a shop, a supermarket or a showroom, where a door that opens itself brings people in and keeps the air conditioning inside between customers. At a clinic or a hospital, where hands are full or not clean, and a door nobody touches is better. At an office lobby or a hotel entrance, often paired with an access control reader so the door opens only for a card.
Inside a building, between a reception and a corridor, or at the entrance to a cold room. A door that opens for a trolley and closes behind it is the usual answer there.
Automatic sliding door price, and what changes it
The rate starts at ₹85,000 per door set, supplied and fitted, before GST. That is a single sliding leaf of toughened glass, the operator with its sensors and safety beams, and the header. A double door costs more, because it has two leaves and a longer header.
Fixed glass side panels, a frosted or printed glass, a battery backup, an access control reader and a lock on the door are each priced on their own lines. The opening width and height set the glass size and so the figure.
You get a written price after the measuring visit, with the glass, the operator, the header and each extra listed.
From the measuring visit to a door that opens for you
Send a photo of the entrance on WhatsApp with its rough width and height, or book the measuring visit. At the visit we measure the opening, check what the header will fix to, agree the leaf layout and where the power point and any access control cable will arrive.
Then you get the written price. Once you agree, you pay an advance, because the glass is cut and toughened to your sizes. Fitting takes one to two days once the glass arrives: the header goes up first, then the fixed panels, then the leaves, and the operator is set up and tested with you.
You pay the rest when the door opens for a person from both sides, stops on the safety beam, and closes cleanly.
Power, service and what we do not do
The operator runs from a normal power point in the header, which an electrician brings to the top of the opening before we fit. Access control, CCTV and fire alarm links are wired by those trades and connect to the controller's terminals.
An automatic door is a machine that runs hundreds of times a day, so the rollers, the belt and the sensors want a check once a year. We service the doors we fit. We do not do civil work to widen an opening, the mains wiring, or the access control system itself.























